Synthesis of amphetamine – how to prepare amphetamine at home
Ironically, more and more young people are interested in the question: “How to prepare Amphetamine at home?”. This is due to the growing popularity of the stimulant, the simplicity of its synthesis and manufacturing in non-specialized places for this. Everyone can create their own clandestine laboratory for the synthesis of amphetamine. To begin with, you need to have minimal knowledge of organic chemistry in order to understand what kind of equipment you need to purchase in order to later use it to prepare Amphetamine. The easiest and most accessible way to obtain information on the preparation of Amphetamine is to go to the Internet and go to various drug sites where instructions on how to make it at home are available in an accessible form. These articles are very simple to understand, in them, to the smallest detail, are described all sorts of decompositions on the reagents necessary for the correct and efficient synthesis of matter.
In fact, the synthesis of amphetamine is the restoration of ephedrine (a psychoactive and very toxic alkaloid contained in coniferous plants), and this can be achieved by condensation reaction of two active components: phenylacetone and methylamine.
As it turned out, the Internet is teeming with hundreds of recipes for preparing Amphetamine, but in fact not all of them are effective, because require a good knowledge of chemistry, certain skills and experience in the synthesis of amphetamine.
How to prepare Amphetamine at home (one of the available methods)
In general terms, the whole process of preparing a drug takes about 10-15 hours (this depends on the number of people involved in the process and their experience). We take (we buy, we find) ephedrine or one of its analogues: red phosphorus or iodine in crystals.
Preparing the soil for synthesis. It is necessary to collect a lot of coverage from matchboxes, which we tear from its sides. Then we place the sidewalls in a container, which is poured with hydrochloric acid solution. We move this container to the water bath, where we hold it until the contents, and in particular the sides of the match boxes, turn red (of course, on the one hand). Only after this, the vessel is removed from the plate, acid is poured off, and the sidewalls are washed with water, and then again with acid. Further, these “graters” again pour acid, but for five minutes, and after drain, wash. At this stage, you should not save on water and acid, because the quality of the original product depends on this. Thus, “graters” get rid of all excess impurities. Now the red plates can be put on a hard surface and begin to rub them. As a result, we get pure red phosphorus. Next, take a large syringe, pre-seal the spout. In the piston of the syringe, we make several through holes, and then we fill it with iodine, add 2-3 milliliters of water, and only at the end – 10 drops of acid. Now we are in no one waiting for a miracle – the solution should be rebuilt, after which we squeeze out the moisture from the syringe, and at this time the remains of iodine are mixed with red phosphorus and ephedrine. The synthesis finale is simple: the medicine is poured into the strainer and placed in a container with water, but in such a way that it covers it. We are waiting for five minutes, and then we are already washing. The resulting preparation is placed in a glass dish, which is filled with hydrochloric acid, and after boiling it for about an hour. The original product is filled with gasoline, and we settle it.